Unlock ALL iPhone 4 (No SAM, No Jailbreak) including latest iOS 5.1 baseband 4.12

Features of version 15


- Unlock all iPhone 4 basebands, including latest iOS 5.1 with baseband 4.12

- No SAM required, No Jailbreak required, No Codes required

- No Cables required, No Logs required, No Software or Apps required

- No Need to Cut your SIM, No Need Technical Knowledge required

- No 112 or any special number dialing required

- Use any SIM card, without voiding your warranty, on any provider!.

- Supports 3G, EDGE, MMS, Facetime Supports All Network SIM Cards 2G, 3G, WCDMA.



The unlock procedure using UPDATE V15

1. Programm your GEVEY AIO with version 15 as if you normally do then

write the correct IMSI at this step

- if the IMSI provided is wrong then unlock & activation will fail !


2. Go to General->Reset->Erase all Content and Settings
(YOU MUST DO THIS STEP !)


3. Reboot the phone


4. Insert GEVEY together with simcard into phone


5. Perform the required settings and Activate the phone using iTunes or WiFi

(iTunes works best)


6. Take out the GEVEY while leaving your simcard inside the phone


7. Power cycle (off then on) the phone!

- Your simcard is still inside.


9. Wait for the activation screen to appear


10. Connect to iTunes or press Next (if Wifi is available)


11. If you see the message "Activation failed" in iTunes then take out the usb

cable, put the cable back and your phone will be locked to your simcard in no time;

- The same applies to Wifi activation, try 2-3 times if it fails;


12. You are DONE, in few seconds you can see the singnal bars and start

using your iPhone 4.


Your iPhone is now locked to your simcard !


Keep your GEVEY in case you need to use another simcard with your

iPhone 4 or you perform a 'Erase all Content and Settings' in the future.







GEVEY SIN AIO V2 (NO CUT) UPDATES SOFTWARE

Version 1.4 (64 bits systems ONLY) direct download links:
1. NoCutUpdateV1.4.zip
2. NoCutUpdateV1.4.zip
3. NoCutUpdateV1.4.zip


Version 1.3 (32 bits systems ONLY) direct download links:
1. NoCutUpdateV1.3.zip
2. NoCutUpdateV1.3.zip
3. NoCutUpdateV1.3.zip






GEVEY AIO V1 (NORMAL) UPDATES SOFTWARE

Version 2.7 (64 bits systems ONLY) direct download links:
1. UpdateV2.7.zip
2. UpdateV2.7.zip
3. UpdateV2.7.zip


Version 2.5 (32 bits systems ONLY) direct download link:
1. UpdateV2.5.zip
2. UpdateV2.5.zip
3. UpdateV2.5.zip









****************************************

IMPORTANT INFO:

How to use your GEVEY after FREE UPDATES are over ?
- If you have already completed FREE updates your GEVEY will be stuck in UPDATE MODE.

- If you press the Read SN button the software will read the SN from your GEVEY

and also restore your GEVEY to the last working state.

- So if your GEVEY was updated with version xx on last successful update,

by using

Read SN button you will be able again to use that version



!! ATTENTION !!

If your GEVEY stopped updating during the

UPDATE procedure because of a FAILURE

DON’T USE THE READ SN BUTTON TO GET

YOUR GEVEY OUT OF UPDATE MODE !!

If you do that it might render your GEVEY UNUSABLE

if the last update WAS NOT SUCCESSFUL.

So you can use this button to get your GEVEY out of UPDATE MODE only if your GEVEY

reached the maximum number of FREE updates !